The Victron Phoenix Inverter 12/500 VE.Direct - 230v. 50 Hz. Schuko is a pure wave current inverter of the Phoenix range with a power of 500W of direct current (1000W Peak) at 12V voltage. Convert your 12V installation to a 220V system to be able to connect any domestic appliance to your system in a totally safe way trusting the leading brand in electronic devices for clean energy. The Victron Inverter PIN121501200 has a pure wave sine wave output, provides a high clean and stable power with impeccable efficiency. Victron Phoenix inverters also allow parallel connection of up to 6 inverters in single-phase, two-phase and three-phase configuration to gradually increase the power of your installation. Undoubtedly, Victron Energy has become a world leader in the world of camper and the world of clean energy in general thanks to its famous pure wave inverters as this Victron Phoenix 12/500 VE.Direct - 230v. 50 Hz. Schuko. Trust Victron Energy's experience to turn your installation into a safe stable installation.


Features:


- VE.DIRECT COMMUNICATION PORT


The VE.Direct port can be connected to:


- A computer (VE.Direct to USB interface cable required).


- Apple and Android smartphones, tablets, mackbooks and other devices (VE.Direct to Bluetooth Smart dongle required).


Fully configurable:


- Alarm trigger levels and low battery voltage reset.


- Low battery voltage disconnect and reset levels.


- Dynamic disconnect: load-dependent disconnect level.


- Output voltage 210 - 245V


- Frequency 50 Hz or 60 Hz


- ECO mode on/off and ECO mode level sensor Monitoring: - Input/output voltage and current, % load and alarms.


- PROVEN RELIABILITY


The full bridge plus toroidal transformer topology has proven its reliability over many years. The inverters are short-circuit proof and protected against overheating, whether due to overload or high ambient temperature.


- HIGH STARTING POWER


Necessary for starting loads such as converters for LED lamps, halogen lamps or power tools.


- ECO MODE


In ECO mode, the inverter will go into standby when the load drops below a preset value (minimum load: 15W). Once in standby, the inverter will activate briefly (adjustable; default: every 2.5 seconds). If the load exceeds the preset level, the inverter will remain on.


- REMOTE CONTROL ON/OFF SWITCH


A remote On/Off switch can be connected to a two-phase connector or between the battery positive and the left contact of the two-phase connector.