Heavy-duty JKS relocation

Correct Jeep Wrangler TJ or LJ rear suspension geometry with a JKS rear track bar relocation bracket. The design compensates for improper track bar alignment / orientation after adjusting rotation of the axle housing. Requires 3" to 6" suspension lift. Correction improves driveline angles after suspension has been lifted and a CV-type driveshaft installed. The heavy duty steel bracket attaches directly to factory track bar mount on your Jeep's axle housing. It relocates the mounting point to reduce track bar operating angle and improve handling at speed. Eliminates binding and premature bushing wear. Minimizes risk of track bar failure. Protective powder coat finish resists corrosion.

Specs:

    Heavy-duty reinforcement bracket attaches directly to factory track bar mount on axle housing
    Angled design corrects geometry on lifted vehicles with rotated axle housing or CV-type driveshaft
    Premium steel construction is laser cut, formed and folded for maximum strength
    Economical bolt-on solution minimizes risk of track bar failure on the trail
    Protective powder coat finish resists corrosion

Notes:

    Fits vehicles equipped with CV-type driveshaft ONLY
    NOT compatible with right hand drive vehicles