Durable, high-quality product from JKS
Improve the handling of your lifted Jeep Wrangler JL or Gladiator JT with JKS front control arm correction brackets. Designed for use with 2-6" lift kits the brackets improve control arm operating angle to mimic or improve on factory arm angles as well as improve anti-dive during braking. Lowering the control arm mounting point slightly places the arms closer to the axle mount which corrects caster and geometry caused by the lifted ride height. Two mounting hole positions correct geometry for given lift heights. Heavy duty, 1pc, fully boxed 7GA steel brackets install inside the factory upper and lower control arm mounts with the factory hardware. The fully gusseted design you extra confidence both on and off road.
Specs:
Reduced control arms angles allow the front suspension to more naturally roll over bumps
Correct control arm operating angle and mimic factory suspension geometry
Improve the front drive shaft CV joint operating angles through full wheel travel
Heavy duty steel construction, double powder coated
Work with factory and aftermarket adjustable control arms
Easy, bolt on installation
Sold in pairs
In the box:
(2) Control arm correction brackets
Mounting hardware
Notes:
Ideal lift range is 2-4,5" but can be used up to 6"
Requires 2" of front bump stop extension for adequate clearance at full suspension compression (sold separately)