The DFR 4X4 adjustable front spring spacers for the Jeep Wrangler JK offer us an elevation of the front axle regulating between a minimum of 40 mm and a maximum of 110 mm.
Perfect accessory to recover the lost height when mounting steel bumpers and winch.
One of the most common inconveniences that we find when we already have our 4x4 vehicle prepared is to mount new accessories that weigh a lot, the front of the vehicle has to regain that height lost due to excess weight, and not only because of the weight but also because of the direction, a correct position so that the direction does not vary from its starting position.
After increasing the weight of the front axle we would need stiffer springs, an option that makes the vehicle uncomfortable on the road, ceasing to be flexible on the track and trialeras, the best solution is the DFR 4X4 Adjustable Front Spring Spacers, which allows you to recover the height lost from the extra weight and use.

The DFR 4X4 Adjustable Front Spring Spacers are independently adjustable so we can correct the lateral and horizontal height of the vehicle.

This product requires homologation of the vehicle in ITV.( Spain )
How to install:

1st Measure the height of the vehicle to know what you need to raise and preassemble the DFR Adjustable Front Spring Spacers kit to the necessary measure.
2nd Remove the front axle springs.
3º With a rotaflex, reduce the inside of the original spring rubber base by 3 mm so that it enters the threaded body without deforming.
4º Remove the compression stop by levering and cut 4 mm or lower the flared tube, paint to protect from rust and mount the compression stop.
5º Place the screw, insert the DFR 4X4 Adjustable Spring Spacer kit, put the nut and tighten.
6th Assemble the springs and when the Jeep is on the ground, correct the lateral and horizontal height.
7º Retighten the nuts of the threaded body and then align the steering.

It is already assembled, that simple and fast.