VIAIR’s Medium Duty Onboard Air System is a pre-packaged compressed air solution that provides a 33% duty cycle 325C compressor, 2.5 gallon air tank, and all components needed to install basic vehicle-based pneumatics.
Please Note: Use thread sealant for proper installation. Teflon tape is not recommended.
Properly sealed, recommended torque for 1/8″ is 10 ~ 11 ft. lbs.
Recommended torque for 1/4″ and 3/8″ is 12 ~ 15 ft. lbs.
| FEATURES |
|---|
| – 2.5 Gallon VIAIR Air Tank |
| – 325C VIAIR Compressor |
| – Dash Panel Gauge with ON/OFF Switch |
| – Pressure Switch with Relay (110 PSI on, 145 PSI off) |
| – Reducer: 1/8” (F) to 1/4” (M) |
| – 1/4” Quick Connect Coupler (M) |
| – 1/4” 175 PSI Safety Valve |
| – 1/4” Drain Cock |
| – 20ft. 12-Gauge Wire with Inline Fuse Holder |
| – 4” Strip of Continuous Grommet Material |
| – Accessory Airline |
| – Electrical Connections |
| SPECIFICATIONS |
|---|
| – 12-Volt |
| – Permanent Magnetic Motor |
| – Duty Cycle: 33% @ 100 PSI |
| – Max. Working Pressure: 150 PSI |
| – Max. Amp Draw: 21 Amps |
| – Ingress Protection Rating: IP67 |
| – |
| – |
| – |
| – |
| – |
| – |
All Fittings are NPT rated unless otherwise noted.
| PSI | CFM | A | BAR | LPM | A |
|---|---|---|---|---|---|
| 0 | 1.59 | 14 | 0 | 45.0 | 14 |
| 10 | 1.40 | 16 | 1.0 | 37.6 | 16 |
| 20 | 1.24 | 16 | 2.0 | 34.1 | 18 |
| 30 | 1.20 | 18 | 3.0 | 32.3 | 18 |
| 40 | 1.17 | 18 | 4.0 | 29.1 | 20 |
| 50 | 1.08 | 19 | 5.0 | 26.0 | 21 |
| 60 | 1.01 | 20 | 6.0 | 23.7 | 21 |
| 70 | 0.93 | 21 | 7.0 | 21.5 | 21 |
| 80 | 0.87 | 21 | 8.0 | 19.7 | 21 |
| 90 | 0.82 | 21 | 9.0 | 18.0 | 21 |
| 100 | 0.77 | 21 | 10.0 | 16.5 | 21 |
| 110 | 0.72 | 21 | |||
| 120 | 0.68 | 21 | |||
| 130 | 0.64 | 21 | |||
| 140 | 0.60 | 21 | |||
| 150 | 0.57 | 21 |
* Supply Voltage: 13.8 Volts
| 2.5 Gallon Tank | Fill Rate |
|---|---|
| 0 to 145 PSI | 4 min. 15 sec. (± 10 sec.) |
| 110 to 145 PSI | 1 min. 25 sec. (± 05 sec.) |
| 31″ x 10.5″ | Fill Rate |
| 0 to 30 PSI | 4 min. 40 sec. (± 10 sec.) |
| 15 to 30 PSI | 2 min. 30 sec. (± 05 sec.) |
| 33″ x 12.5″ | Fill Rate |
| 0 to 30 PSI | 6 min. 40 sec. (± 15 sec.) |
| 15 to 30 PSI | 3 min. 20 sec. (± 10 sec.) |
Our workshops 4x4 Leer más.
If you would like to read more about the history of Sahara4x4, please read this See more info.
Sahara cuatro por cuatro s.l.
B-63517643
C/ Bacardi nº9
08902 Hospitalet de llobregat
